Car · Mazda
Mazda Cosmo: A rotary dream in a jet-age shape
A rotary dream in a jet-age shape. The Mazda Cosmo is an automobile produced by Mazda from 1967 to 1995. During its production run, the Cosmo served as a "halo" vehicle for Mazda, with the first Cosmo successfully launching the Mazda Wankel engine.

1968 Mazda Cosmo-Sport 01.jpg · Mytho88 · CC BY-SA 3.0
Unmodified image file; scaled to fit the page. Photo remains under its stated license.
At a glance
| Maker | Mazda |
|---|---|
| Type | Car |
Series L10A/L10B (1967–1972)
The first Mazda to bear the Cosmo name (called the 110S on models intended for export) was (along with the NSU Ro80) one of the first production cars to feature a 2-rotor Wankel engine. A prototype was presented at the 1964 Tokyo Motor Show, one month before the 1964 Summer Olympics, and after the introduction of the NSU Spider at the Frankfurt Motor Show; 80 pre-production Cosmos were produced for the Mazda test department (20) and for dealership testing (60) between 1965 and 1966. Full production began in May 1967 and lasted through 1972, though Cosmos were hand-built at a rate of approximately one per day, for a total of 1,176 (343 Series I cars and 833 Series II cars). The car was also featured in the show The Return of Ultraman.
Racing
In 1968, Mazda went racing with the Cosmo. They selected one of the most grueling tests in Europe to prove the reliability of the rotary engine, the 84-hour Marathon de la Route at the legendary Nürburgring circuit in Germany. Two mostly stock Cosmos were entered, along with 58 other cars. One major change to the cars' 10A engines was the addition of a novel side- and peripheral-port intake system: A butterfly valve switched from the side to the peripheral port as RPM increased. The engines were limited to 130 PS (96 kW) to improve durability.
The cars ran together in fourth and fifth place for most of the race, but the all-Japanese car was retired with axle damage in the 82nd hour. The other car, driven by Belgians, completed the race in fourth overall. This was to be the only racing outing for the Cosmo—the next Mazda race car would be a Familia Rotary (R100).
Series I
The Series I/L10A Cosmo was powered by a 0810 two-rotor engine with 982 cc of displacement and produced about 110 hp (thus the 110S name used in export markets). It used a Hitachi four-barrel carburetor and an odd ignition design—two spark plugs per chamber with dual distributors. A four-speed manual transmission and 14-inch wheels were standard.
In Japan, the installation of a rotary engine gave Japanese buyers a financial advantage when it came time to pay the annual road tax in that they bought a car that was more powerful than a traditional inline engine, but without having the penalty for having an engine in the higher above-one-litre tax bracket.
The front suspension was a coil-sprung double wishbone design with an anti-roll bar. The rear used a leaf-sprung de Dion tube. Unassisted 10 inch (254 mm) disk brakes were found in front with 7.9 inches (201 mm) drum brakes in the rear. Performance in the quarter-mile (400 m) was 16.4 s, with a 115 mph (185 km/h) top speed. The price was lower than the Toyota 2000GT at 1.48 million yen (US$4,100).
Series II
The Series II/L10B was introduced in July 1968. It had a more-powerful 128 hp (95 kW)/103 lb·ft (140 N·m) 0813 engine, power brakes, 15 inch wheels and a 5-speed manual transmission. The wheelbase had been expanded by 15 cm for more room and a better ride. This Cosmo was good for over 120 mph (193 km/h) and could accelerate to cover a quarter-mile (400 m) in 15.8 s.
Visual changes included a larger grille under the front bumper with two additional vents to each side of this "mouth". Only 833 were ever made, and fewer than six Series II models were initially imported into the United States. The price was up a bit to 1.48 million yen (US$4,390).
Comedian and former talk show host Jay Leno owns a 1970 Series II Cosmo which was featured on the North American Speed Channel series My Classic Car in March 2006. It was believed to be the only remaining Series II Cosmo in the United States, though the original Cosmo 10A engine has been replaced with a 12A from an RX-7.
However, Mazda's U.S. division "found another in the garage of Phoenix-area car collector Glenn Roberts and made an offer that he couldn't refuse," according to Car and Driver magazine's September 2007 issue ("A Tale of Two Rotaries"). There is a further Series II Cosmo in a collection in Alberta, Canada.
A 1970 Mazda Cosmo Sport Series II L10B Coupe sold in January 2015 for US$110,000 inclusive premium at auction at Bonhams.
A 1970 Cosmo sports is currently, (September 2024), being fully restored by an English based Company called Yorkshire Car Restorations on YouTube. It has the original Wankel engine (10A) and original 5-speed gearbox. It has been fully stripped to bare metal and new re-fabricated parts and panels fitted, where necessary.
Cosmo 21 Concept (2002)
At the 2002 Tokyo Auto Salon, Mazda presented the Cosmo 21, a retro styled 21st century reinterpretation of the original Cosmo 110s of 1967 to commemorate the 35th anniversary of the Cosmo.
Model history and photograph may show different years or specifications. These are model-reference photographs, not vehicles offered for sale. No photographer or manufacturer endorsement is implied.
Sources and image credit
Structured record: Wikidata Q607198 · checked 2026-11-03. The At a glance table is drawn from that record; fields the record does not contain are omitted.
Text adapted from the English Wikipedia article “Mazda Cosmo” (en.wikipedia.org), CC BY-SA 4.0 · checked 2026-11-03.